Gtech AirRAM MK2 - Cleaning the Filters; Removing Filter Housing; Removing the Filter; Cleaning Inner Shroud

10
Holding onto the AirRAM with one hand, pull
the bin handle and li the bin out of
the AirRAM.
Remove the filter from the inner shroud,
by twisting and pulling.
Tap the inner shroud over a bin to remove any
excess dirt.
Wash the filter under a tap. Squeeze out any
excess water then let it dry completely before
reinserting into the AirRAM. Recommended
water temperature 40°C. Do not use
detergent or soaps. Never put bin back
without filter inside. You could damage
the motor.
Pull the filter out of the filter housing.
Tap the dirt from the filter and tip any
dirt from the filter housing.
Wash the filter if necessary.
Cleaning the filters - do this once a month or more frequently depending on use.
4092_AR29_UK_manual_aw.indd 104092_AR29_UK_manual_aw.indd 10 10/02/2020 14:3010/02/2020 14:30