Gtech AirRAM MK2 - Filter and Brush Bar Maintenance; Replacing Filters; Brush Bar Jam Warning; Removing Brush Bar

11
Slide the filter onto the inner shroud. Slide the filter and inner shroud into the filter
housing.
If the brush bar jams during use, the AirRAM
will stop and the LEDs will appear red. Before
checking for a blockage, remove the battery.
Rest the AirRAM on its side and locate
the brush bar button on the right hand side.
Press the button inwards and then pull
the brush bar out from the bottom of
the AirRAM.
Replacing the filters
Removing and cleaning the brush bar
4092_AR29_UK_manual_aw.indd 114092_AR29_UK_manual_aw.indd 11 10/02/2020 14:3010/02/2020 14:30