Carefully turn your eBike upright (the rear wheel
will not be fully secure) and locate the tension
marker on the frame of your eBike.
Push down on the belt directly above the tension
marker with your index nger. Make sure that
there is 1cm of movement when you push on
the belt.
If the tension is not correct, turn your eBike
upside down and adjust the belt tension adjuster
screws. Tighten the screws to create more
tension and loosen them slightly to reduce
tension. Check the belt tension again.
With your eBike upside down, tighten the nuts
on either side of the wheel by placing the tool
through them and turning clockwise.
To Next Page
Loading...
