Make sure that the slots in the bolt and ring are
not facing upwards or forwards, as this will allow
water and dirt to enter more easily.
While holding the bolt in place, tighten the ring
securely so that it is against the brake
lever mount.
Adjusting the brakes
Locate the reach adjuster ring where the brake
cable enters the brake lever on the handlebars.
Unscrew the ring by turning it anti-clockwise.
Unscrew the reach adjuster bolt by a few turns.
This will reduce the amount of travel in the brake
lever. Make sure that the brake lever no longer
travels all the way back to the handlebars.
You should not be able to pull the brake levers all the way back to the handlebar grip. If this occurs,
you will need to adjust the brake lever reach.
To Next Page
Loading...
