Preparation
Setting the handlebars .................................................................... 7
Setting the saddle height ................................................................ 8
Adjusting the saddle height ............................................................. 9
Adjusting the saddle angle and travel ............................................ 10
Storing the Gtech tool .................................................................. 11
Removing the battery ................................................................... 12
Attaching the battery .................................................................... 13
Loosen the three bolts in the order shown, turn-
ing anticlockwise, using the Gtech tool.
Rotate the handle bar clockwise to the correct
postion. The handle bars should be aligned
straight with the main frame. Tighten the three
bolts in the same order, turning clockwise, using
the Gtech tool.
1
2
3
You will need to use your Gtech tool for the
following instructions. The Gtech tool is located
under the battery, in the centre of the battery
cradle. See page 11
Setting the handlebars
To Next Page
Loading...
