To Next PageTo Next PageWhat to do if my GTO Gate Opener beeps 5 times with 2 seconds pause?
If your GTO Gate Opener is beeping 5 times with a 2-second pause, it indicates that no movement was detected from the motor twice. You should check the path of the gate for any obstructions and ensure that the motor is not jammed.
Why does my GTO Gate Opener beep once every 5 seconds when the gate is moving?
The GTO Gate Opener beeps once every 5 seconds when the gate is in motion because there is no AC power present and the battery voltage is low. Check the GFI, circuit breaker, connections in the field wiring connection compartment, battery connections, battery voltage, and perform a load test on the battery.
What does it mean when my GTO GP-SW100 Gate Opener beeps 4 times with a 2 seconds pause?
If your GTO gate opener is beeping 4 times with a 2-second pause, this indicates that the motor has moved in the wrong direction. Check the BLDC speed control connections on the logic board and motor drive board.
What does it mean when my GTO GP-SW100 Gate Opener beeps 3 times with a 2 seconds pause?
If your GTO gate opener is beeping 3 times with a 2-second pause, it means that the gate has traveled outside the maximum allowable limit of the operator. Check the limit sensor connections on the logic board.
Why does my GTO GP-SW100 Gate Opener beep once every 10 seconds when idle?
The GTO Gate Opener beeps once every 10 seconds when idle because the battery is critically low. If dip switch #4 is in the FAIL SAFE position and the gate is at the OPEN Limit, or if it's in the FAIL SECURE position and the gate is at the CLOSED Limit, the operator will be disabled until AC power is restored and the battery voltage has reached 26 VDC. Check the GFI, circuit breaker, connections in the field wiring connection compartment, battery connections, battery voltage, and perform a load test on the battery.
What does it mean when my GTO GP-SW100 Gate Opener beeps 2 times with 2 seconds pause?
If your GTO Gate Opener is beeping twice with a 2-second pause, it means that the logic board does not detect the motor drive board connections. Check the BLDC speed control connections on the logic board and motor drive board.
What to do if GTO GP-SW100 beeps 1 time with 2 seconds pause?
If your GTO Gate Opener beeps once with a 2-second pause, it indicates that the revolution counter circuit board is not being detected. Check the connections for the limit sensors on the logic board.
General| Model | GP-SW100 |
|---|---|
| Type | Gate Opener |
| Operating Temperature | -4°F to +122°F |
| Control Type | Remote Control |
| Safety Features | Obstruction Detection |
