GTO GTO/PRO SW-4000 User Manual

©
2002 GTO, Inc.
R4200 INST
rev - 03/11/04
WARNING!
This equipment is similar to other gate or door equipment and meets or exceeds
Underwriters Laboratory Standard 325 (UL 325). However, gate equipment has
hazards associated with its use and therefore by installing this product the
installer and user accept full responsibility for following and noting the
installation and safety instructions. Failure to follow installation and safety
instructions can result in hazards developing due to improper assembly. You agree
to properly install this product and that if you fail to do so GTO, Inc. shall in no
event be liable for direct, indirect, incidental, special or consequential damages or
loss of profits whether based in contract tort or any other legal theory during the
course of the warranty or at any time thereafter. The installer and/or user agree to
assume responsibility for all liability and use of this product releasing GTO, Inc.
from any and all liability. If you are not in agreement with this disclaimer or do
not feel capable of properly following all installation and safety instructions you
may return this product for full replacement value.
READ ALL INSTRUCTIONS CAREFULLY AND COMPLETELY before
attempting to install and use this automatic gate operator. This gate operator
produces a high level of force. Stay clear of the unit while it is operating and
exercise caution at all times.
All automatic gate operators are intended for use on vehicular gates only.
This product meets and exceeds the requirements of UL 325, the standard which regulates gate operator safety,
as established and made effective March 1, 2000, by Underwriters Laboratories Inc.
Installation Manual
for installing the GTO/PRO SW-4200 with the
GTO/PRO SW-4000 in a dual application
FOR PROFESSIONAL INSTALLATION ONLY!
3121 Hartsfield Road • Tallahassee, Florida, USA 32303
Telephone GTO Sales: 1-800-543-GATE (4283) or (850) 575-0176 • Fax (850) 575-8912
or GTO Technical Service: 1-800-543-1236 or (850) 575-4144 • Fax (850)575-8950
www.gtopro.com
®
DC-SERIES
®
DC-SERIES

GTO GTO/PRO SW-4000 Specifications

General

Brand	GTO
Model	GTO/PRO SW-4000
Category	Gate Opener
Language	English

Summary

Gate Operator Safety

Consumer and Installation Safety

Covers essential safety for gate operator users and installation practices to prevent injury.

Entrapment Protection and Alarms

Details secondary safety means and audio alarms for entrapment prevention as per UL standards.

Gate Warning Signs and Precautions

Explains required warning signs, gate safety, and pedestrian access precautions.

System Components and Specifications

Parts Identification

Lists and illustrates all components and hardware included with the SW-4000/SW-4200 gate operators.

Technical Specifications

Provides detailed operational and power specifications for the gate operator system.

Installation and Setup Procedures

Installation Overview and Preparation

Guides through initial gate preparation and provides an overview of the pull-to-open installation.

Mounting Hardware and Operator

Details the steps for installing post brackets, gate brackets, and mounting the operator arm.

Powering, Controls, and Stops

Covers installing the transformer, control box, connecting power, and setting closed position stops.

DIP Switch Settings and Limit Programming

Explains control board DIP switches for configuration and programming gate open/closed limits.

System Operation and Maintenance

Adjusting Sensitivity and Safety Devices

Guides on adjusting obstruction sensitivity and connecting safety devices like sensors.

Connecting Accessories and Setting Limits

Details accessory connections, setting the open position limit, and output relay functions.

Maintenance, Troubleshooting, and Repair

Provides guidance on routine maintenance, diagnosing issues, and procedures for repair service.

Specialized Installations and Accessories

Covers column installation, push-to-open configurations, and lists available accessories.