32
6.1 - How to change the hydraulic oil6.1 - How to change the hydraulic oil
6.1 - How to change the hydraulic oil6.1 - How to change the hydraulic oil
6.1 - How to change the hydraulic oil
The spent oil must be replaced with new oil of the type indicated on page 28 every 400 hours of
operation. To change the oil, proceed as follows.
• Make sure that the log pusher of the machine is fully retracted.
• Unscrew the cap shown in Fig. 7/A on page 3 and remove it completely.
• Position a container under the log splitter that can hold 4 litres of oil; then tilt the machine to empty
the oil (Fig. 7/B).
• Tilt the machine in the other direction (Fig. 7/C) and pour in 2.6 litres of oil of one of the types indicated
on page 28.
• Clean the dipstick and insert it to check that the oil level is between the two notches on the stem.
• Clean the cap and washer thoroughly and re-tighten completely but carefully so as not to break the
threading of the cap.
,,
,,
,
WARNING:WARNING:
WARNING:WARNING:
WARNING:
NEVER MIX OIL WITH GENERAL WASTE! USED OIL MUST BE DISPOSED OF ACCORDING TONEVER MIX OIL WITH GENERAL WASTE! USED OIL MUST BE DISPOSED OF ACCORDING TO
NEVER MIX OIL WITH GENERAL WASTE! USED OIL MUST BE DISPOSED OF ACCORDING TONEVER MIX OIL WITH GENERAL WASTE! USED OIL MUST BE DISPOSED OF ACCORDING TO
NEVER MIX OIL WITH GENERAL WASTE! USED OIL MUST BE DISPOSED OF ACCORDING TO
CURRENT REGULATIONS IN THE COUNTRY WHERE THE MACHINE IS USED.CURRENT REGULATIONS IN THE COUNTRY WHERE THE MACHINE IS USED.
CURRENT REGULATIONS IN THE COUNTRY WHERE THE MACHINE IS USED.CURRENT REGULATIONS IN THE COUNTRY WHERE THE MACHINE IS USED.
CURRENT REGULATIONS IN THE COUNTRY WHERE THE MACHINE IS USED.
6.2 - Refilling the hydraulic oil6.2 - Refilling the hydraulic oil
6.2 - Refilling the hydraulic oil6.2 - Refilling the hydraulic oil
6.2 - Refilling the hydraulic oil
Periodically check the oil level, which must be between the two notches on the oil cap dipstick (Fig. 7/A).
If the level is low, refill using the recommended types of oil on page 28.
6.3 - Sharpening the wedge6.3 - Sharpening the wedge
6.3 - Sharpening the wedge6.3 - Sharpening the wedge
6.3 - Sharpening the wedge
After long periods of operation and when required, sharpen the wedge of the log splitter using a fine-
toothed file and taking care to remove any burrs or crushed parts of the metal.
7 - TROUBLESHOOTING7 - TROUBLESHOOTING
7 - TROUBLESHOOTING7 - TROUBLESHOOTING
7 - TROUBLESHOOTING
7.1 - How to free a jammed log7.1 - How to free a jammed log
7.1 - How to free a jammed log7.1 - How to free a jammed log
7.1 - How to free a jammed log
• Release both controls: the log pusher will be fully retracted.
• Insert a triangular block of wood under the jammed log and activate the log splitter until the wedge
is pushed completely under the piece of wood (fig.8, page 3).
• Repeat the operation with larger pieces of wood until the log is completely free.
,,
,,
,
WARNING:WARNING:
WARNING:WARNING:
WARNING:
•
NEVER ASK FOR THE ASSISTANCE OF ANOTHER PERSON WHEN FREEING A JAMMED LOG.NEVER ASK FOR THE ASSISTANCE OF ANOTHER PERSON WHEN FREEING A JAMMED LOG.
NEVER ASK FOR THE ASSISTANCE OF ANOTHER PERSON WHEN FREEING A JAMMED LOG.NEVER ASK FOR THE ASSISTANCE OF ANOTHER PERSON WHEN FREEING A JAMMED LOG.
NEVER ASK FOR THE ASSISTANCE OF ANOTHER PERSON WHEN FREEING A JAMMED LOG.
•
NONO
NONO
NO
T TT T
T TT T
T T
O TRO TR
O TRO TR
O TR
Y TY T
Y TY T
Y T
O EXTRAO EXTRA
O EXTRAO EXTRA
O EXTRA
CT THE LCT THE L
CT THE LCT THE L
CT THE L
OG HITING IT WITH A TOG HITING IT WITH A T
OG HITING IT WITH A TOG HITING IT WITH A T
OG HITING IT WITH A T
OOL AND KEEPING THE FOOOOL AND KEEPING THE FOO
OOL AND KEEPING THE FOOOOL AND KEEPING THE FOO
OOL AND KEEPING THE FOO
T BLT BL
T BLT BL
T BL
OCKEDOCKED
OCKEDOCKED
OCKED
,,
,,
,
THIS COULD CATHIS COULD CA
THIS COULD CATHIS COULD CA
THIS COULD CA
USE THE BREAKAUSE THE BREAKA
USE THE BREAKAUSE THE BREAKA
USE THE BREAKA
GE OF THE MOGE OF THE MO
GE OF THE MOGE OF THE MO
GE OF THE MO
TT
TT
T
OR BLOR BL
OR BLOR BL
OR BL
OCK (FIGOCK (FIG
OCK (FIGOCK (FIG
OCK (FIG
. 10 P. 10 P
. 10 P. 10 P
. 10 P
AA
AA
A
GE 3).GE 3).
GE 3).GE 3).
GE 3).
•
ALL THE SAFETY RULES DESCRIBED IN CHAPTER 3 “SAFETY” ON PAGE 29 APPLY WHENALL THE SAFETY RULES DESCRIBED IN CHAPTER 3 “SAFETY” ON PAGE 29 APPLY WHEN
ALL THE SAFETY RULES DESCRIBED IN CHAPTER 3 “SAFETY” ON PAGE 29 APPLY WHENALL THE SAFETY RULES DESCRIBED IN CHAPTER 3 “SAFETY” ON PAGE 29 APPLY WHEN
ALL THE SAFETY RULES DESCRIBED IN CHAPTER 3 “SAFETY” ON PAGE 29 APPLY WHEN
CARRYING OUT THE OPERATIONS DESCRIBED ABOCARRYING OUT THE OPERATIONS DESCRIBED ABO
CARRYING OUT THE OPERATIONS DESCRIBED ABOCARRYING OUT THE OPERATIONS DESCRIBED ABO
CARRYING OUT THE OPERATIONS DESCRIBED ABO
VE.VE.
VE.VE.
VE.
THE MANUFTHE MANUF
THE MANUFTHE MANUF
THE MANUF
ACTURER SHALL NOT BE HELD RESPONSIBLE IN ANY WAY FOR INJURY TO PERSONSACTURER SHALL NOT BE HELD RESPONSIBLE IN ANY WAY FOR INJURY TO PERSONS
ACTURER SHALL NOT BE HELD RESPONSIBLE IN ANY WAY FOR INJURY TO PERSONSACTURER SHALL NOT BE HELD RESPONSIBLE IN ANY WAY FOR INJURY TO PERSONS
ACTURER SHALL NOT BE HELD RESPONSIBLE IN ANY WAY FOR INJURY TO PERSONS
AND ANIMALS OR DAND ANIMALS OR D
AND ANIMALS OR DAND ANIMALS OR D
AND ANIMALS OR D
AMAGE TO OBJECTS CAUSED BY IMPROPER USE OF THE MACHINE ORAMAGE TO OBJECTS CAUSED BY IMPROPER USE OF THE MACHINE OR
AMAGE TO OBJECTS CAUSED BY IMPROPER USE OF THE MACHINE ORAMAGE TO OBJECTS CAUSED BY IMPROPER USE OF THE MACHINE OR
AMAGE TO OBJECTS CAUSED BY IMPROPER USE OF THE MACHINE OR
FF
FF
F
AILURE TO COMPLY WITH THE REGULATIONS DESCRIBED.AILURE TO COMPLY WITH THE REGULATIONS DESCRIBED.
AILURE TO COMPLY WITH THE REGULATIONS DESCRIBED.AILURE TO COMPLY WITH THE REGULATIONS DESCRIBED.
AILURE TO COMPLY WITH THE REGULATIONS DESCRIBED.
To Next Page
Loading...
Need help?
General
