11
2.06 Accessories
Transverse drive motor.
The transverse drive motor makes the hoist fully automatic. It is built into the
DH 2000 without changing the outer dimensions and the visual impression of
the hoist.
When the hoist is provided with the drive motor, the spped is gradually incre-
ased to 8 metres / minute to ensure a smooth up-start.
IR remote control.
The IR remote control is often used with the hoist with transverse drive motor,
enabling the user to “ call “ the hoist and thus to a certain degree be indepen-
dent of the carer.
Important:
When the user is independent, the IR remote control sender should be attac-
hed to the user, so that it will always be within the reach.
Lifting Slings
Please ask the distributor for a special leaet on Lifting Slings.
Extension strap
This is used if the distance between rail and oor exceeds 3 metres, and is
ordered separately. If E.G. the distance is 3.5 metres between rail and oor
you should order an extension strap of 0.5 metres length.
Switch track
The switch track is used when it is necessary to divide
a single track rail system into two tracks.
The manual switch track is activated by pulling one of
the strings hanging down from the switch track. The DH 2000 is driving in the
direction of the string pulled. The electric switch track is activated by pressing
the key on the hand control once.
Safety
Via mechanical safety devices the product secures the hoist
against running off the rail or getting jammed.
Turntable
The turntable is used in rail systems where it is
necessary to combine 3 or 4 directions.
The DH2000 is positioned in the centre of the tur-
ntable prior to use. The turntable is activated by
pressing the key of the hand control. When acti-
vating the key once, the turntable turns 90°. Keep
pressing the key till the desired direction is reached.
Safety
Via mechanical safety devices the product secures the hoist
against running off the rail or getting jammed.
© Guldmann GB-896/08/08 • # 900662
© Guldmann GB-896/08/08 • # 900662
To Next Page
Loading...