14
5.03 Service check - Allround
During the inspection a service report shall be made, describing what has
been checked and exchanged.
Worn or defective parts shall be replaced by new spareparts from
V. Guldmann A/S.
1 Visual check of the product.
• Check the product for wear and tear
• Check the product for any deformity
• Check that the product does not show any other diciencies.
2 Test of the product, as during normal use.
• Check all functions on the product, with and without load,
• ( eg. Up, down, forward, backward, out and in ).
• Check the emergency lowering is operational.
• Check the emergency stop is operational.
• Check the charging indicator is operational.
3 Dismantle the cover / fence.
4 Check the electrical condition of the products
• Check the batteries and measure the:
• Input / Voltage
• Output / Voltage
• Check electrical functions and signals
• Check all wirings for errors and defects
• Check wire lead-ins
• Check all possible conections, plugs etc.
5 Check the mechanical condition oft the product
• Clean the product for dirt and other impurities
• Inspect and evaluate the vital parts of the product
• Exchange defective and worn
• Grease the product
6 Mount the cover / fence
7 Point 1.2 is carried out one more time as a control function
8 Have new errors or problems arisen in point 7?
• If new problems have arisen, go back to point 3
• If no problems have arisen, nish the inspection.
9 When a service inspection including service work or exchange of com-
ponents has taken place, the nal check should comprise a weight test
with the product’s nominal load.
If the DH 2000 has been silicone-coated for use in wet environment, this coa-
ting must be renewed if it shows sign of drying.
© Guldmann GB-896/08/08 • # 900662
© Guldmann GB-896/08/08 • # 900662
To Next Page
