Guldmann GL5 - 6.02 Cleaning and Disinfection; Recommended Cleaning Agents; 7.00 Troubleshooting; Hand Control Input Error

15
© Guldmann GB/US-1688/12/2011 • # 553658_4.01 © Guldmann GB/US-1688/12/2011 • # 553658_4.01
© Guldmann GB/US-1688/12/2011 • # 553658_4.01
© Guldmann GB/US-1688/12/2011 • # 553658_4.01
1 Visualcheckoftheproduct
• Check the product for wear and tear
• Check the product for any deformity
• Check that the product does not show any other diciencies.
2 Liftingmotor/actuator
• Check the lifting motor/actuator for visible outer damage and leaking oil as
well as any abnormal sound during operation.
• According to the manufacturer’s instructions the lifting motor/actuator
shall be exchanged after 11.000 cycles or at least every 5 years.
3 Testoftheproduct,asduringnormaluse
• Check all functions on the product, with and without load,
(Ie. Up, down, forward, backward, out and in).
• Check the emergency lowering is operational.
• Check the emergency stop is operational.
• Check the charging indicator is operational.
4 Checktheelectricalconditionoftheproducts
• Check the batteries and measure the:
• Input/Voltage
• Output/Voltage
• Check electrical functions and signals
• Check all wirings for errors and defects
• Check wire lead-ins
• Check all possible conections, plugs etc.
5 Checkthemechanicalconditionofttheproduct
• Clean the product for dirt and other impurities
• Inspect and evaluate the vital parts of the product
• Exchange defective and worn parts of the product
• Check and tighten all moving parts
• Grease the product.
6 Point3iscarriedoutonemoretimeasacontrolfunction
7 Havenewerrorsorproblemsariseninpoint7?
• If new problems have arisen, go back to point 3
• If no problems have arisen, nish the inspection.
8 Whenaserviceinspectionincludingserviceworkorexchangeofcom-
ponentshastakenplace,thenalcheckshouldcompriseaweighttest
withtheproduct’snominalload