GW Instek ASR-2000 Series - Page 19

19
Nondestructive
maximum input voltage
±10 V
Gain resolution
0.1 times
Accuracy
±5 % (DC, or 45Hz ~ 65 Hz, gain is at initial value,
with rate voltage output, no load)
EXT: Output voltage (V) = External signal input (V) x Gain (V/V)
Voltage Setting Signal Input (AC-VCA Mode)
Specification
Factory Default
Gain setting range
100 V range: 0.0 to 250.0 times
100
200 V range: 0.0 to 500.0 times
200
Input terminal
BNC connector
Input impedance
1 MΩ
Input voltage range
DC 0 ~ 2.5 V
Nondestructive
maximum input voltage
±10 V
Accuracy
±5 %
External Signal Input (AC+DC-ADD, AC-ADD Mode)
Specification
Factory Default
Gain setting range
100 V range: 0.0 to 250.0 times
100
200 V range: 0.0 to 500.0 times
200
Input terminal
BNC connector
Input impedance
1 MΩ
Input voltage range
±2.5 V (A/D resolution 12 bit)
Nondestructive
maximum input voltage
±10 V
Input frequency range
DC to 999.9 Hz (sine wave)
DC to 100 Hz (other than sine wave)