GW Instek GDS-2102A - Page 153

CONFIGURATION
153
5. Use the side menu to select the trigger source
type.
Range
Channel 1 ~ 4 (Alternate On/Off),
EXT (Ext Probe: Volt/Current,
Attenuation: 1mX~1kX ), AC Line
6. Press Coupling from the bottom
bezel menu to select the trigger
coupling or frequency filter
settings.
7. Choose the coupling from the side
menu.
Range
DC, AC
8. Press Reject to toggle the rejection
filter from the side menu.
Range
HF Reject, LF Reject, Off
9. Toggle Noise Rejection On or Off
from the side menu.
Range
On, Off
10. From the bottom menu press Slope
to toggle the slope type.
Range
Rising edge, falling edge, either
11. To set the external trigger level,
select Level from the bottom bezel
menu.