FUNCTION GENERATOR -SERIES
INSTRUCTION MANUAL
7-2.Fuse Replacement Procedure
When you proceed calibration or maintenance of the Function
Generators, if you want to replace the fuse, the upper cover must be removed
according to the following steps:
1).The handle must be turned downward 90 degrees first.
FUNCTION GENERATOR -SERIES
INSTRUCTION MANUAL
2).Pull apart the handle from the Function Generator. Please turn the
handle left and right side slightly, that will make easier to pull off the
handle.
3).There are two washers inside of two holes (the joints of handle and case)
respectively. Please use a screwdriver to pry open these washers.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
