9. Open the LM Flash Programmer.
10. Select the Configuration tab.
11. In the Quick Set drop down list, choose Manual
Configuration.
12. From the Interface area:
To update the “Master”, choose Serial (UART).
Set the COM Port and Baud Rate settings (must be
115200).
If you are not sure of the COM port settings, click
the Device Manager button. When Windows
Device Manager dialog opens, expand the “Ports
(COM & LPT)” node. The COM port and baud
rate that is assigned to the target should be listed.
Leave the transfer size at the default 60.
To Next Page
Loading...
