GW Instek LCR-800 Series - Setting the Nominal Component Value; Setting the Maximum Value Limit; Setting the Positive Tolerance Percentage

LCR-800 Series User Manual
50
RANGE setting:
! Press F1/F2 key to select the white inverted characters “RANGE”.
! PressF3 or F4 key to select up or down value within 1~4 range shown as
Figure 8-10 below.
EXIT
SET BIN BIN SUM
MODE:C/D CIRCUIT:SER.
SPEED:SLOW DISPLAY:BIN
C D
BIN
F:1.0000kHz MANU
V:1.000 V INT.B OFF
:1 C.V : OFF
DELAY:00000mS AVG : 1
UP
Press F2 key
to the
RANGE
RANGE
Press F3 . F4
key to select
UP.DOWN
DOWN
Figure 8-10
C.V setting:
! Press F1/F2 key to select the white inverted characters “C.V”.
! Press F3 or F4 key to select ON or OFF shown as Figure 8-11 below. For
further details, please refer to 4-5-5.
Figure 8-11
EXIT
SET BIN BIN SUM
MODE:C/D CIRCUIT:SER.
SPEED:SLOW DISPLAY:BIN
C D
BIN
F:1.0000kHz MANU
V:1.000 V INT.B OFF
RANGE:1 : OFF
DELAY:00000mS AVG : 1
ON
Press F2 key
to the OFF
C.V
Press F3 . F4
key to select
ON.OFF
OFF