GW Instek LCR-800 Series - Page 70

LCR-800 Series User Manual
66
File_Num: Set 4 codes of file numbers from 0001 to 9999. When
the test results data reaches to the number of 10000 can
be stored with a file number.
Test Result File
_
Name File
_
Num Filename
1-10000 LCR_ 0001 LCR
_
0001.Txt
10001-20000 LCR_ 0002 LCR
_
0002.Txt
20001-30000 LCR_ 0003 LCR
_
0003.Txt
30001-40000 LCR_ 0004 LCR
_
0004.Txt
40001-50000 LCR_ 0005 LCR
_
0005.Txt
50001-60000 LCR_ 0006 LCR
_
0006.Txt
|
99980001-99990000 LCR
_
9999 LCR
_
9999.Txt
FileNum Reset (refer to the following figure): File_Num is 0001.
Ps. File_Num will be continued from last file number of test result. If
last file number is end at 0006, next file number is started from 0007
when re-power on the unit.
If want to start from 0001, reset the FileNum (refer to Figure 9-8).
Figure 9-8
4) Data
Result : Display test results. When the test results data reaches to the
number of 10000 will be stored in a file automatically. If want
to store the data less than the number of 10000, must exit the
LCR-VIEW first (the data can be stored automatically), then
execute again the LCR-VIEW to start another counting of test