GYS GYSFLASH 9.24 User Manual

7
GYSFLASH 9.24
EN
Maintenance:
• If the power cable is damaged, it must be replaced by the
manufacturer, its after sales service or an equally qualified person
to prevent danger.
Regulations:
• Machine compliant with European directives.
• The certificate of compliance is available on our website.
• EAC Conformity marking (Eurasian Economic Community)
Waste management:
• This product should be disposed of at an appropriate recycling
facility. Do not throw away in a domestic bin.
GENERAL DESCRIPTION
Your Gysash is ideal to charge most lead-acid batteries, often used for cars and many other vehicles. The GYSFLASH can be used safely
for : GEL (gel electrolyte), AGM (Absorbant Glass Mat), EFB ( Enhanced Flooded Battery)WET, MF (Maintenance Free), CA (Calcium)...
The Gysash 9.24 is designed to charge :
- 6V batteries (3*2V elements) from 18Ah to 220Ah and yo to 300Ah for maintenance charge,
- 12V batteries (6*2V elements) from 18Ah to 220Ah and up to 300Ah for maintenance charge,
- 24V batteries (12*2V elements) from 15Ah to 125Ah and up to 170Ah for maintenance charge.
The GYSFLASH 9.24 is tted with an integrated temperature probe that ensures that the voltage output
is adapted to the ambient temperature, for an optimal charging performance. This adjustment ensures a
highly precise charge, relative to the ambient temperature.
START UP
1. Connect the charger to the battery.
2. Plug the charger to the mains (single phase 220-240Vac 50-60Hz).
3. Select the mode by pressing the button. After roughly 5 seconds, the charge starts automatically.
4. During the charge, the device indicates the charge progress. When indicator blinks, the battery is ready to start the vehicle.
Once indicator stays on, the battery is fully charged.
5. The charge can be interrupted at any time by unplugging the mains plug or pressing the button.
6. After charging, disconnect the charger from the mains, then disconnect the charger’s connections from the battery.
CHARGE MODES
• Modes and Options description :
CHARGE Mode 6V (7.3V/9A) :
Mode designed to charge and maintain (oating charge) 6V batteries. 8 step automatic maintenance charge cycle.
CHARGE Mode 12V (14.6V/9A) :
Mode designed to charge and maintain (oating charge) 12V batteries. 8 step automatic maintenance charge cycle.
CHARGE Mode 24V (29.2V/6A) :
Mode designed to charge and maintain (oating charge) 24V batteries. 8 step automatic maintenance charge cycle.
REFRESH Option :
Option which add an extra step (step 7) to the charge cycle to restore deeply discharged batteries.
: this option is not recommended for charging sealed batteries.
Recommendation : Check the battery’s water level and if necessary, perform with a Refresh charge.

GYS GYSFLASH 9.24 Specifications

General

Brand	GYS
Model	GYSFLASH 9.24
Category	Battery Charger
Language	English