Why GYS Welding System has no current and thermal protection is on?
If your GYS Welding System isn't delivering current and the yellow thermal protection indicator is on, the thermal protection has likely activated. Wait for the cooling cycle to complete, which takes about 2 minutes. The indicator (6) should then switch off.
Why is the arc unstable on my GYS Welding System?
An unstable arc in your GYS Welding System can be caused by several factors: * A fault due to the tungsten electrode: Use an electrode size more suitable to the thickness of your metal. * Use an tungsten electrode properly prepared. * Gas flow too high: Reduce the gas flow.
What to do if GYS Welding System indicator is on but no current?
If the indicator light is on but your GYS Welding System isn't delivering any current, the earth clamp or the electrode holder might not be properly connected to the unit. Check these connections to ensure they are secure.
Why does tungsten oxidize with GYS Welding System?
If the tungsten becomes oxidized and dull at the end of welding with your GYS Welding System, it could be due to issues with the welding area or gas flow. Check and tighten every gas connection. Also, wait for the electrode to cool down before switching off the gas flow. Also, check that the earth is connected to the +.
Why do I feel tingling from my GYS Welding System?
If you feel a tingling sensation when touching the case of your GYS Welding System while it's connected to the mains, it indicates a faulty earth contact. Check the plug and the earth of your installation.
Why do I feel a tingling sensation when touching my GYS GYSMI E160 Welding System?
If you experience a tingling sensation when touching the GYS Welding System, it indicates that the unit isn't properly grounded. To resolve this, check the plug and the grounding of your electrical network.
Why does the electrode melt when using my GYS GYSMI E160 Welding System?
If your GYS Welding System's electrode melts, it's likely due to a polarity error. Ensure that the earth clamp is properly connected to the positive (+).
Why does the tungsten electrode get oxidized on my GYS Welding System?
If the tungsten electrode gets oxidized and tarnishes at the end of welding with your GYS Welding System, it may be caused by the welding zone. Protect the welding zone from air flows.
What to do if my GYS GYSMI E160 Welding System display turns on and off quickly?
If your GYS Welding System display turns on for a second and then turns off, it indicates a voltage issue. Have your electrical installation checked to ensure it meets the required voltage (single phase 230V).
How to fix a GYS GYSMI E160 Welding System that is not delivering current and the yellow indicator is on?
If your GYS Welding System isn't delivering current and the yellow thermal defect light is on, the thermal protection has activated. Allow approximately 2 minutes for cooling. The indicator light will turn off when it's ready.
General| AC input voltage | 230 V |
|---|---|
| Power consumption | 7.5 kVA |
| AC input frequency | 50 - 60 Hz |
| Welding processes | - |
| Maximum welding current | 160 A |
| Minimum welding current | 10 A |
| Variable welding current | Yes |
| Maximum electrode diameter | 4 mm |
| Minimum electrode diameter | 1.6 mm |
Weight and Dimensions| Depth | 210 mm |
|---|---|
| Width | 100 mm |
| Height | 270 mm |
| Weight | 4600 g |
To Next Page
