GYS GYSPACK PRO - Battery Replacement; Battery Replacement Procedure

13
GYSPACK PRO
EN
Translation of the original instructions
BATTERY REPLACEMENT :
2
1
Product Battery Type Voltage (V) Capacity (Ah)
Dimensions
(cm)
Battery ref
GYSPACK PRO Lead- acid battery 12 22 34 x 20 x43 53151
To replace the battery :
• The booster must be disconnected form the power supply.
• First the back panel must be unscrewed (14 screws) and removed.
• Once the back panel is removed, the battery front appears (cf illustration). The battery is connected to the GYSPACK
PRO at two points : at the - terminal -
1
and at the + terminal
2
. To remove the battery, remove the 2 screws
that enable the connection between the battery and the GYSPACK PRO at the terminals + and -.
When putting a new battery, make sure to observe the polarities of both the battery
and the GYSPACK PRO. Terminal - on the left, terminal + on the right (cf illustration).
Put the 2 screws and washers back, tighten the nuts (recommended torque wrench 4
N.m).
• Place the booster’s backpanel screws back on.
130.ua — all for cars!
130.ua