MIM-4BSE Module 101
Jumper Settings The MIM-4BSE uses jumpers to set matched resistance for ISDN BRI S/T interfaces.
The use of 100-ohm resistance on an ISDN BRI S/T interface depends on jumper
settings. The following figure shows the jumper settings, where all the ISDN BRI
S/T interfaces are using 100-ohm resistance.
Figure 113 Jumper settings of the MIM-4BSE (example)
The following table describes how to set jumpers.
Supported service ISDN
ISDN supplementary services
Multi-user number
Sub-addressing
Backup
Table 60 Interface attributes of the MIM-4BSE
Attribute Description
S1
S2 S3
S4 S5
S6 S8
S7
23
01
To Next Page
Loading...
