H3C MSR 20 - Sic-1 Gec; Attribute; Connector

42 CHAPTER 2: SMART INTERFACE CARDS
SIC-1GEC
Introduction 1-port 10/100/1000 Mbps electrical and fiber Ethernet interface SIC card
(SIC-1GEC) has the following functions:
■ Receipt, transmission and processing of GE data stream;
■ CE electrical and fiber interface access;
■ 1000/100/10 Mbps on electrical interface;
■ 1000 Mbps on fiber interface
n
For H3C MSR 20-40 and MSR 30/50 series routers, a SIC-1GEC interface card can
only be installed in SLOT2 or SLOT4.
Interface Attributes The attributes of SIC-1GEC interface are shown in the following table.
Table 16 Interface Attributes of the SIC-1GEC
Attribute Description
Connector RJ-45
Interface type MDI
Frame format Ethernet_II
Ethernet_SNAP
IEEE 802.2
IEEE 802.3
Operation mode 10/100/1000 Mbps autosensing
Full/half duplex
Network protocol IP
Novell IPX
Table 17 Attributes of SFP module
SFP module
name Wavelength Connector
Fiber
specification
Maximum
transmission
distance
1000BASE-SX-SF
P
850 nm LC 50/125 µm
multi-mode fiber
550 m (1804.5 ft.)
62.5/125 µm
multi-mode fiber
275 m (902.2 ft.)
1000BASE-LX-SF
P
1310 nm 9/125 µm
single-mode
fiber
10 km (6.2 mi.)
1000BASE-LH-SF
P
40 km (24.9 mi.)
1000BASE-ZX-LR
-SFP
1550 nm
1000BASE-ZX-V
R-SFP
70 km (43.5 mi.)
1000BASE-ZX-U
R-SFP
100 km (62.1 mi.)