118 CHAPTER 3: MULTIFUNCTIONAL INTERFACE MODULES
n
■ VCPM is provided to users together with MIM-2VE1. Users can select VPM
module as needed.
■ VPM module is installed on the main board of MIM-2VE1.
Interface Attributes The interface attributes of MIM-2VE1 are given in the following table.
Interface LEDs MIM-2VE1 panel is shown in the following figure:
Figure 133 MIM-2VE1 panel
The following table describes the LEDs on the MIM-2VE1 panel:
n
The MIM-2VE1 module is 1U in height, occupying two slots.
Table 78 Interface attributes of MIM-2VE1
Attribute Description
Connector DB-15
Number of connectors 2
Operating mode CE1
ISDN PRI
R2
Interface rate 2.048 Mbps
Cable E1 120-ohm balanced twisted pair
cable
75ohm-to-120ohm adapter
Supported service 1) R2 signaling
2) DSS1 signaling
3) IP Fax
4) General VoIP features in Comware
Table 79 Description of the LEDs on the MIM-2VE1 panel
LED Description
LINK OFF means no link is present; ON means a
link is present.
ACTIVE OFF means no data is being transmitted or
received. Blinking means there is data
being transmitted or received.
To Next Page
Loading...
