70 CHAPTER 3: MULTIFUNCTIONAL INTERFACE MODULES
■ Operating speeds of 1000 Mbps, 100 Mbps, and 10 Mbps, as well as
auto-sensing;
■ Half-duplex/full duplex, autosensing
Interface Attributes The interface attributes of MIM-1GBE/MIM-2GBE are given in the following table:
Interface LEDs MIM-1GBE/MIM-2GBE panel is shown in the following figure:
Figure 67 MIM-1GBE panel
Figure 68 MIM-2GBE
The following table describes the LEDs on the MIM-1GBE/MIM-2GBE panel.
Interface Cable MIM-1GBE/MIM-2GBE uses both crossover and straight-through cables for
connection.
Table 39 Interface attributes of MIM-1GBE/MIM-2GBE
Attribute
Description
MIM-1GBE MIM-2GBE
Connector RJ-45
Number of connectors 1 2
Interface type MDI/MDIX
Interface standard 802.3, 802.3u, 802.3ab
Cable type Ethernet cable
Operating mode 10/100/1000 Mbps auto-sensing
Half-duplex/full duplex, autosensing
Table 40 Description of the LEDs on the MIM-1GBE/MIM-2GBE panel
LED Description
LINK OFF means no link is present; ON
means a link is present.
ACT OFF means no data is being
transmitted or received; blinking
means data is being received or/and
transmitted.
To Next Page
Loading...
