To Next Page

To Previous Page

{ Execute the display counters rate outbound interface command on the peer end

to view the outbound traffic rate statistics.

The end with a lower rate drops packets.

2. Use the display interface command to view the traffic statistics for the interface to verify

that no packets are dropped by the interface.

3. Collect the following information for the interface:

{ Execute the display hardware internal module interface-name interface-number

statistics command in probe view to collect the interface statistics.

{ Execute the display hardware internal module interface-name interface-number

status command in probe view to collect the status information.

{ Execute the display hardware internal module interface-name interface-number

reg 1 command in probe view to collect the FPGA information.

{ Execute the display hardware internal module interface-name interface-number

reg 2 command in probe view to collect the MAC information.

{ Execute the display hardware internal module interface-name interface-number

reg 3 command in probe view to collect the PHY information.

{ Execute the display hardware internal ibd pkt-info slot slot-number

slot-number command in probe view to collect inter-card packet statistics.

4. Contact H3C Support.

Related commands

This section lists the commands that you might use for troubleshooting Ethernet interfaces.

Command Description

display interface

Displays Ethernet interface information.

display arp

[ [

all

dynamic

multiport

static

] |

vlan

vlan-id |

interface

interface-type

interface-number ] [

count

verbose

]

Displays ARP entries.

display counters rate inbound interface

Displays outbound traffic rate statistics.

display counters rate outbound interface

Displays inbound traffic rate statistics.