User Manual
H3C S1016/1024 Ethernet Switch
Chapter 2
Switch Installation
2-1
Chapter 2 Switch Installation
2.1 Installation Preparations
2.1.1 Security Tips
To avoid any device impairment or bodily injury caused by
improper use, take the precautions listed below:
z Before cleaning the switch, please unplug the switch
connector first. Do not clean the switch with wet cloth or
liquid.
z Do not place the switch near water or in any damp area.
Prevent water or moisture from entering the switch chassis.
z Keep the switch to operate in clean environment. Dust
buildup on the chassis may result in static absorption,
shortening the life span of the switch and causing
communication failure.
z S1016/1024 use air cooling approach for they just generate
a small amount of heat. Keep the switch in good ventilation
condition. Do not place one switch on another.
z The switch can operate normally under proper voltage input.
Make sure that the operating voltage is consistent with that
labeled on the switch.
z Do not open the chassis while the switch is in operation. Do
not open the chassis if not necessary, even when the switch
is not powered on.
To Next Page
Loading...
Need help?
General
