User Manual
H3C S1016/1024 Ethernet Switch
Chapter 2
Switch Installation
2-2
Caution:
There is a seal on one mounting screw of the chassis of the S1000
series. It must remain untouched unless the agent is on the spot to
maintain your switch. Please contact your local agent and get
permission if you wish to open the chassis. Otherwise, you will have to
take the consequences of your incorrect operations.
2.1.2 Installation Environment
The S1016/1024 can be installed in the corridor or inside the
room. These issues must be taken into account:
z There is enough space (more than 10 cm) near the
air-intake hole and the ventilation hole of the switch for heat
dissipation of the switch chassis.
z The installation site has a perfect cooling system.
z The workbench where the S1016/1024 is located is solid
enough to hold the S1016/1024and its accessories.
z The workbench is well grounded.
2.1.3 Electromagnetic Environment
The switch in use may be affected by exterior interference in
radiation and conduction way. Therefore, you need to be sure to:
z Use a monophase three-wire power socket with Protection
Earth (PE) as the AC power supply unit is a TN system.
Thereby, the filter circuit in the equipment can effectively
filter interference from the power supply system.
To Next Page
Loading...
Need help?
General
