User Manual
H3C S1016/1024 Ethernet Switch
Chapter 2
Switch Installation
2-3
z Keep the switch far away from high-power radio launchers,
radar launchers, and equipment with high-frequency and
high-current.
z Use electromagnetic shielding if necessary. For example,
you can use shielded port cable.
z Travel the port cable indoors. Outdoor cabling is prohibited,
so as to prevent the signal port from possible damages that
may be caused by overvoltage and overcurrent of lightning
strike.
2.2 Installing the Switch
Note:
During installation, you are recommended to wear an ESD-preventive
wrist strip, which can be connected to the grounding screw of the
cabinet, to eliminate possible static damage to the switch.
2.2.1 Sticking Feet
Step 1: Remove the paper covering the adhesive end of the feet.
Step 2: Stick the adhesive end of the feet to the circular recess on
the bottom of the chassis.
2.2.2 Connecting Power Cord
Step 1: Check if the required power supply unit is used.
Step 2: Insert one end of the power cord to the input socket of the
switch and the other end to the socket of the external power supply.
To Next Page
Loading...
Need help?
General
