H3C S7500E Series Instruction Manual

15
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter Ethernet interface
view.
interface
interface-type
interface-number
N/A
3. Enable EEE on the
Ethernet interface.
eee enable
By default, EEE is disabled on
an Ethernet interface.
Setting the statistics polling interval
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter Ethernet interface
view.
interface
interface-type
interface-number
N/A
3. Set the statistics polling
interval for the Ethernet
interface.
flow-interval
interval
By default, the statistics polling
interval is 300 seconds.
To display the interface statistics collected in the most recent statistics polling interval, use the
display interface command.
Forcibly bringing up a fiber port
As shown in Figure 2, a GE/10-GE/40-GE/100-GE port uses separate fibers for transmitting and
receiving packets. The physical state of the fiber port is up only when both transmit and receive fibers
are physically connected. If one of the fibers is disconnected, the fiber port does not work.
To enable a fiber port to forward traffic over a single link, you can use the port up-mode command.
This command forcibly brings up a fiber port, even when no fiber links or transceiver modules are
present for the fiber port. When one fiber link is present and up, the fiber port can forward packets
over the link unidirectionally.

H3C S7500E Series Specifications

General

Brand	H3C
Model	S7500E Series
Category	Switch
Language	English