22
Figure 35 Completing RAID creation
The screen as shown in Figure 36 opens.
After the RAID volume is created, the RAID volume is displayed in the Volumes section. To
view details about a RAID volume, click the RAID volume. The right pane displays the details
about a RAID volume, including RAID level, strip size, RAID status, and number of NVMe
drives.
Figure 36 Viewing the created RAID volume
Configuring hot spare drives
1. Open Intel VROC 6.0 PV GUI.
2. Select the NVMe drive to be configured as the hot spare drive from the Devices list, and then
click Mark as spare in the Disk Properties section, as shown in Figure 37.
To Next Page
Loading...
Need help?
General
