H3C UniServer R4900 G5

50
Figure 85 Deleting a RAID array
Uninitializing drives
IMPORTANT:
When the
storage controller operating mode is HBA, you cannot uninitialize drives. To uninitialize
the
se drives, you must first set the storage controller operating mode to RAID: hide RAW, RAID:
expose RAW, Auto Volume, or Simple Volume.
Perform this task to clear data, Adaptec metadata, and reserved space on drives, and remove the
system partitions. After a drive in Ready state is uninitialized, it returns to the raw state.
To uninitialize drives:
1. On the PMC RAID management screen, select Logical Device Configuration, and press
Enter.
2. On the screen as shown in Figure 86, select Uninitialize Drives, and press Enter.