H3C UniServer R4950 G3 User Manual

19
Verifying VMD status
1. Access the CLI of the server.
2. Access Device Manager to examine VMD status:
 If the screen displays the information in the Storage controllers section as shown in
Figure 30, it indicates that VMD has been enabled, and the server supports configuring
RAID arrays.
 If the screen displays Standard NVM Express Controller or none for NVMe drive
information in the Storage controllers section. For information about how to enable VMD
for RAID configuration, see "Configuring VMD settings."
Figure 30 Verifying VMD status
Obtaining third-party tools
Sign in to Intel at https://platformsw.intel.com/KitSearch.aspx to obtain Intel VROC management
tools. This document uses Intel VROC 6.0 PV GUI to configure NVMe RAID arrays as an example.
Configuring RAID arrays
1. Open Intel VROC 6.0 PV GUI, and then click Create Volume…, as shown in Figure 31.

H3C UniServer R4950 G3 Specifications

General

Brand	H3C
Model	UniServer R4950 G3
Category	Server
Language	English