H3C WA2612-AGN - Configuring Common Settings for Console Login

14-6
Figure 14-5 Configuration page
Step4 You can then configure the AP or check the information about the AP by executing commands. You
can also get help by typing ?. For information about the commands, see the following sections.
Configuring Common Settings for Console Login
Table 14-3 lists the common settings for console port login.
Table 14-3 Common settings for console port login
To do… Use the command… Description
Enter system view
system-view
—
Enter console user interface view
user-interface console
0—
Baud rate
speed
speed-value
Optional
The default baud rate is 9,600 bps.
Check mode
parity
{
even
|
mark
|
none
|
odd
|
space
}
Optional
By default, the check mode of the console
port is set to
none
, which means no check
bit.
Stop bits
stopbits
{
1
|
1.5
|
2
}
Optional
The default stop bits of a console port is 1.
Data bits
databits
{
5
|
6
|
7
|
8
}
Optional
The default data bits of a console port is 8.
Console port
configuration
Define a shortcut
key for terminating
tasks.
escape-key
{
default
|
character }
Optional
By default, you can use
Ctrl+C
to terminate
a task.