H3C WA2612-AGN - 11 Basic Configurations; Displaying Configuration

11-1
z The models listed in this document are not applicable to all regions. Please consult your local sales
office for the models applicable to your region.
z Support of the H3C WA series WLAN access points (APs) for features may vary by AP model. For
more information, see Feature Matrix.
z The interface types and the number of interfaces vary by AP model.
11 Basic Configurations
This chapter includes these sections:
z Displaying Configuration
z Basic System Configuration
z CLI Features
z Introduction to CLI
Displaying Configuration
You can use the display commands to view the configurations of an AP, which fall into the following
categories:
z Current configuration – The currently running configuration on the AP. The current configuration is
stored in a temporary storage medium. You must save a setting you have made so it can survive a
reboot.
z Saved configuration – Configuration saved in a configuration file, which can survive a reboot.
Follow these steps to display AP configurations:
To do… Use the command… Remarks
Display the current
configuration of the
AP
display current-configuration
[ [
configuration
[ configuration ] |
interface
[ interface-type ] [ interface-number ] ]
[
by-linenum
] [
|
{
begin
|
exclude
|
include
}
regular-expression ] ]
Available in any view.
Display a
configuration file
more
file-url
If the file is the configuration file for the next
startup of the AP, you can use this command:
display saved-configuration
[
by-linenum
]
The
more
command is available in
user view.
The
display saved-configuration
command is available in any view.