14-15
Figure 14-11 Set up a local configuration environment
Step4 Execute the following telnet command on the PC.
Figure 14-12 Launch Telnet
Step5 Enter the password when the Telnet window displays “Login authentication” and prompts for login
password. The CLI prompt (such as <Sysname>) appears if the password is correct. If all VTY user
interfaces of the AP are in use, you fail to establish the connection and receive the message that says
“All user interfaces are used, please try later!”. A WA series WLAN AP can accommodate up to 5
Telnet connections at same time.
Step6 After successfully Telnetting to an AP, you can configure the AP or display information about the AP by
executing corresponding commands. You can also type ? at any time for help. Refer to the following
chapters for information about the commands.
z A Telnet connection is terminated if you delete or modify the IP address of the corresponding VLAN
interface.
z By default, commands of level 0 are available to Telnet users authenticated by password. See CLI
in the Fundamentals Configuration Guide for information about command hierarchy.
Configuring Common Settings for Telnet Login
Table 14-6 lists the common Telnet settings.
To Next Page
Loading...
