39
SECTION 5 DATA RECALL AND STORAGE
To store sample data, press STORE after the sample measurement
is displayed. Data must be stored if you wish to recall it later for
review, downloading or printing. The following information is
stored for each sample:
• instrument model
• instrument serial number
• chemical form
• concentration
• units
• absorbance
• %T
• date
• time
• sample number
• program number
After the
STORE key is pressed, a flashing question mark icon is
shown in the lower-right portion of the display. In the center of
the display, the next available storage number will appear. If this
storage location is acceptable, press
ENTER to accept it.
To select an empty storage number (between 1 and 99), use the
ARROW keys to scroll to the desired number or enter the desired
number with the numeric keys. Press
ENTER to accept. The
instrument will store the data, then revert back to the
measurement display.
5.1 Recalling Data
To recall data stored in the colorimeter, press the RECALL key.
Use the
ARROW keys to scroll through the stored data. Only data
numbers containing stored sample reading data (of the available
storage numbers 1-99) are displayed in the RECALL menu. For
To Next Page
Loading...
