37
Standard programs
transferring data to a PC and in a network. These interfaces can
be used for the connection of a USB stick, an external USB
keyboard or a USB Barcode handset scanner.
Note: Various accessories can also be connected simultaneously using
a USB hub.
A USB memory stick is used to update data, refer to
section 6.8.2, page 111.
Note: A shielded USB cable must not be longer than 3m!
1. Press PC & Printer in "Instrument Setup".
A list with information about the connections opens.
5.2.7.1 Printer setup
2. Press Printer.
3. Press Setup to display the Printer Setup screen.
Table 3 USB connector
Interfaces Description
USB (Type A) This USB port can be used to connect a printer, a USB memory stick or a keyboard.
USB (Type B)
This USB port is only intended for the connection of the DR 3900 to a PC (with installation of the
corresponding software).
Ethernet
The Ethernet port is intended for data transfer to a PC without installed software or in a local
network . Only use a shielded cable (e.g. STP, FTP, S/FTP) with a maximum length of 20 m for
the Ethernet port.
To Next Page
Loading...
