15
Installation
3.3 Connect the sensor cable
1. Unscrew the protective caps from the controller socket and the cable plug and retain
them.
2. Pay attention to the guide in the plug and push the plug into the socket.
3. Tighten the nut by hand.
Note: Extension cables are available in various lengths (refer to Section 7 Replacement parts and
accessories).
Maximum cable length 100 m (328 ft).
Figure 5 Connect the sensor plug to the controller
CAUTION
Personal injury hazard. Always lay cables and hoses so that they are straight and do not pose a
tripping hazard.
To Next Page
Loading...
