Excel-EN Installation, Commissioning & Operating Manual Approved Document Ref: UI-XLEN-01 Issue 7.0
23
SETUP & PROGRAMMING
PROGRAMMING OPTIONS INDEX
Option/Setting Description Code(s) Page
View History View the last 40 events 1111 24
Set Fault Buzzer Volume Set the fault buzzer volume to high or low
2224 25
Clear All Disablements Remove all disablements which have been set for any zone,
sounder circuit, output or delay
1121 25
Initialise Factory Settings Restores all programming, test modes and disablements back to
factory default settings
1113 25
Panel Wide Settings • Change/remove keypad access code
• Set number of repeater panels on system
• Set time for panel delay timer
• Disable battery monitoring
• Setup internal PCB confi g (add/remove zone cards)
• Change network/repeater comms monitoring type
• Set number of output cards
• Inhibit muted tone beeps
• Inhibit network alarms & faults for panel
• Set number of network slave panels on system (Master Panel
only)
• Inhibit network slave panel fi re & fault buzzer
2123 26
Zone Function Settings • Set zone to latching or non latching
• Set zone to old B.S (short circuit = fi re)
• Set zone for use with MTL5061 I.S. barrier
• Set zone to silent mode (provides visual & audible indication at
the panel but no sounder operation)
• Turn off priority alarm feature for zone
• Turn off detector removal monitoring for zone
• Set detector removal monitoring type for zone (Schottky or
Zener diode detector bases)
• Sprinkler/pump monitoring function
3121 32
Dependancy Modes (False Alarm
Management)
Set panel & zones to dependancy mode A, B or C
2124, 2114, 2134 36
EN54 Sounder Resound Options Set zones to not resound alarms after an initial fi re condition 1114 39
Delays to Outputs Apply delays to outputs in response to selected zones 2323 40
Input Functions Change the default functions of the Class Change and Alert inputs 4141 41
Output Programmability &
Miscellaneous
Set panel outputs to be programmable, switch on fault latching,
invert fault output
4142 42
Panel Output Zonal Responses Set how each output and sounder circuit responds for each zone
(off, continuous or pulsing)
4242, 4342, 3122,
4243
43
Zone of Origin Setting Quick set codes for zone of origin or zonal sounder ringing for
Twin Wire sounder circuits
3311, 3312 45
Panel Output Functional Options Change the default panel output & sounder circuit responses to
‘Silence Alarms’, ‘Evacuate’, ‘Class Change’, ‘Alert’ and ‘Delay’
4244, 3123, 4344 46
Network Output Responses Set local output & relay responses to network fi res 4224 48
Network Sounder Responses Set local sounder cct responses to network fi res 4324, 3224 49
Comms PCB Output Functional
Options
Change the default comms PCB o/p responses to ‘Silence
Alarms’, ‘Evacuate’, ‘Class Change’, ‘Alert’ and ‘Delay’
4343 50
System Diagnostics Mode Tests system PCB confi g setup for fault diagnosis 3114 51
Repeater Programming Repeater panel setup & programming 4443 52
To Next Page
Loading...
