Häfele dialock DTSH - Use Drilling Jig; Drilling Jig Parts A-B; Drilling Jig Parts A-C

50
English
Dialock Door Terminals DTSH, DTSH FH - Status: 07.2008 - 732.29.134
Installation Instructions
Drilling jig parts A-BFig. 16
Select drilling jig with part A-B and 1.
A-C for the individual drill holes:
Insert centring pins for drilling jig 2.
(part A) through the square spindle
and cylinder apertures of the mor-
tise lock. (Fig. 16)
Place drilling jig part B onto the 3.
centring pins from the other side
of the door. Clamp drilling jig into
position using a screw-clamp.
Drilling jig parts A-CFig. 17
Do not damage surface of
door.
Use drilling jig
The drilling jig consists of parts A, B and C. The drilling template must be
prepared in combinations A-B and A-C depending on the drill hole.
Centring
pins