Need help?Do you have a question about the Hafler SE240 and is the answer not in the manual?
Total harmonic distortion and continuous average power per channel into 8 ohms.
Output into 4 ohms, THD, frequency range, and power per channel.
Intermodulation distortion from 1 watt to 120 watts into 8 ohms.
Total Harmonic Distortion at 80 watts for specific frequencies.
Frequency response at different power levels (1 watt and 120 watts).
Channel separation at specific frequencies.
Signal-to-noise ratio referred to 120 watts into 8 ohms.
Input impedance value in ohms.
Input voltage required for 120 watts output into 8 ohms.
Slew rate measurement for a square wave.
Damping factor values for different frequency ranges into 8 ohms.
Power consumption at 120 watts output and quiescent state.
Physical dimensions of the amplifier.
Net weight of the amplifier.
Shipping weight of the amplifier.
Importance of adequate airflow for amplifier reliability and cooling.
Considerations for placing the amplifier near other equipment to avoid hum.
Information on AC power line voltage and remote switching options.
Guidance on using shielded cables for inputs and avoiding hum.
Wire gauge recommendations for speaker connections and terminal types.
Importance of correct speaker phasing and connection polarity.
Internal grounding and connection of external devices.
How to connect speakers and inputs for standard stereo operation.
Instructions for bridging the amplifier for mono output and safety notes.
Guidance on selecting speakers and their power requirements for stereo use.
Tips for optimal speaker placement and room acoustics for sound reproduction.
Information on the pilot lamp, overheating protection, and system recovery.
Information about the amplifier's fuses and when to seek service.
Contact details for the Technical Service Department and troubleshooting advice.
Details on the 3-year warranty, owner responsibilities, and voiding conditions.
To Next Page
General
