hager
"DALI Gateway C00Cx2" software
Functional description
Seite 70 von 130
Activating an OFF-delay
The Off-delay can be activated separately for each group in the plug-in of the DALI Gateway.
Set the "Selection of time delay" parameter in the “Groups - [x] group name – Switch-on/switch-off
behaviour" parameter node to "OFF-delay" or to "ON-delay and OFF-delay". Parameterize the
desired Off-delay time.
The OFF-delay is now enabled. The parameterized time will start after receiving an OFF telegram via
the “Switching” object. A subsequent OFF-telegram will retrigger the time only if the "OFF-delay
retriggerable ?" parameter has been set to "Yes". An OFF-telegram received during the OFF-delay
will terminate the delay and set the switching status to “OFF”.
• Feedback: if a time delay has been preset and if the switching state is changed via the "Switching"
object, the delay time must have elapsed before feedback telegrams will be transmitted. Updates of
the object from "ON" to "ON" or from "OFF" to "OFF" by retriggering during a running delay time has
no effect on the switching status feedback.
• At the end of a disable or forced-control position function, the brightness state received during or set
prior to the function can be resumed. Residual times of time functions are resumed, if they have not
completely elapsed at the time that the disable or forced-control position functions are disabled.
• The time delays have no influence on the Staircase timer functions, if these are enabled.
• A time delay in progress will be completely terminated by a reset of the actuator (bus/mains voltage
failure or ETS programming).
To Next Page
Loading...