Haier 2HUM18HC03/R2 - Installation and Maintenance; Installation Guide and Parts

41
Domestic air conditioner
2HUM18HC03/R2(DB)-SM
Introduction
Outdoor Unit
4
Loading of the battery
1
2
3
4
Parts and Functions
Indoor Unit
OUTLET
INLET
CONNECTING PIPING AND ELECTRICAL WIRING
DRAIN HOSE
Remote controller
Remove the battery cover;
Load the batteries as illustrated.
2 R-03 batteries, resetting key
(cylinder);
Be sure that the loading
is in line with th
e" + "/"-";
Load the battery,then put on the cover again.
The distance between the signal transmission head and the rece-
iver hole should be within 7m without any obstacle as well.
When electronic-sta rted type fluorescent lamp or change- over
wireless telephone is installed in the
ver is apt to be disturbed in receiving
the signals,
so the distance to the indoor unit should be shorter.
type fluorescent lamp or
room, the recei
Note:
Full display or unclear display during operation indicates the
ries have been used up.
Please change batteries.
If the remote controller can't run normally during operation, please
reload several minutes later.
batte
remove the batteries and
Please be subject to the actual produce purchased the
above picture is just from your reference
Please be subject to the actual produce purchased the
above picture is just from your reference
Air Purifying Filter
(inside)
Inlet
1
Inlet grille
2
Outlet
3
(adjust left and
Vertical blade
right air flow)
4
Display board
Horizontal flap
(adjust up and down air flow.
Don't adjust it manually)
Emergency
Switch
6
7
8
5
1
2
3
4
5
6
7
8
1. Mode display
2. Signal sending display
4. FAN SPEED display
5. LOCK display
6. TIMER OFF display
TIMER ON display
LO MED HI
7.TEMP display
17. LOCK button
Used to lock buttons and LCD
display
.
26. RESET button
When the remote controller
appears abnormal, use a sharp
pointed article to press this
button to reset the remote
23. HOUR button
Operation mode
AUTO FANCOOL DRY
Remote controller
HEAT
4
Hint:
Remove the batteries in case won't be in use for a long period. If
there is any display after taking-out, just press reset key.
1
2
3
4
5
10
11
12
13
14
15
16
17
18
23
24
25
26
20
21
22
9
19
7
8
6
Control the lightening and
the indoor
extinguishing of
LED display board.
3. SWING display
8.POWER/SOFT display
9. HEALTH display
10. QUIET button
11. HEAT button
12. COOL button
13. AUTO button
14. FAN button
15. TIMER button
16. HEALTH button
18. LIGHT button
19. POWER ON/OFF button
20. DRY button
21. TEMP button
22. SWING button
24. EXTRA FUNCTION button
25.CANCEL/CONFIRM button
Used to confirm timer and
clock settings.
1
2
3
SMART
8 Installation