Before going to bed, you can simply press the SLEEP
button and unit will operate in SLEEP mode and bring you
a sound sleep.
3 hours before it stops. The temperature is lower than
setting temperature so that it won’ t be too high for your
sleep;
Approx. 6 hrs
Temp. setting
Decreases 2
º
C
Decreases 2
º
C
Unit stop
Rises 1
º
C
Rises 1
º
C
Rises 1
º
C
Temp. setting
In COOL, DRY mode
In HEAT mode
Unit stop
1 hr
1 hr
1 hr
3 hrs
3 hrs
1 hr
SLEEP
operation starts
SLEEP
operation starts
SLEEP
operation stops
SLEEP
operation stops
Press SLEEP
button.
Operation M ode
1. In COOL, DRY mode
1 hour after SLEEP mode
starts, temp. will become 1 ºC
higher than temp. setting. After
another 1 hour, temp. rises by
1 ºC further. The unit will run for
further 6 hours then stops Temp.
is higher than temp. setting so
that room temperature won’ t be
too low for your sleep.
2. In HEAT mode
1 hours after SLEEP mode starts, temp will become
2 ºC lower than temp. setting. After another 1 hour,
temp decrease by 2 ºC further. After 3 more hours,
temp. rises by
1 ºC further. The unit will run for another
3 . In SM ART mode
The unit operates in corresponding sleep mode, which
adapts to the automatically selected operation mode.
4 . When q uiet sleeping function is set to 8 hours the
q uiet sleeping time can not be adjusted. When TIM ER ON
function is set, the q uiet sleeping function can’ t be
set up. After the sleeping function is set up, if user
resets TIM ER ON function, the sleeping function will be
cancelled; the machine will be in the state of timing-
off, if the two modes are set up at the same time, either
automatically, and the other mode will be cancelled.
P ow er F ail u re Res u m e F u nc tion
not start running unless 3 minutes have elapsed. When
the power resumes after power failure, the unit will run
automatically, and 3 minutes later the compressor starts
running.
N ote to th e pow er f ail u re res u m e:
enter function after four beeps.
hearing two sounds.
Com f ortab l e S LEEP
Operation
9
times within five seconds and leave this function after
To Next Page
Loading...
