Operation
Cl oc k s et
Note:
Note:
The distance between the signal transmission head and
the receiver hole should be within 7 m without any obstacle
change- over wireless telephone is installed in the type
in receiving the signals, so the distance to the indoor unit
should be shorter.
Full display or unclear display during operation indicates the
batteries have been used up. Please change batteries.
If the remote controller can’ t run normally during operation,
please remove the batteries and reload several minutes later.
.
Hint:
Remove the batteries in case unit won’ t be in usage for
a long period.
20 . 10 ºC button
special heating set
function: 10 degree
heating maintaining
( valuable for RS)
18 . buttonTIM ER
23 . SWING up/down button
24 . SWING left/right button
19 . buttonCLOCK
26 . HEALTH AIRFLOW button
21. HEALTH button
28 . CODE button
A- b yard
29 . APPLY button
3 0 . ° F/° C button
25. SLEEP button
19
20
21
22
23 24
25
26
27
28
29
3 0
18
22. SM ART button
Used to set SM ART
operation. ( This function
is unavailable on some
models.)
27 . LIG HT button
Control the lightening and
extinguishing of the indoor
LED display board.
Press CLOCK button,
Press “ ” or “ ” to set
correct time.
Each press will increase or
decrease 1min. If the button is
kept pressed, time will change
q uickly.
press APPLY,
starts working.
1
2
3
4
1.SM ART+SLEEP: When thelight sensing function is enabled,
the appliance will be in the
mode. If the appliance
detects that indoor light is weak ( lower than the setting
value) for several minutes, the human sensing function
works automatically. If the appliance detects no movements
of people for 20 minutes , during which the light is weaker
than the setting value , it will enter the “ SM ART SLEEP”
mode automatically. The appliance will operate as per the
sleep curve.( See the“ SLEEP” function in Page 7 ) .
Conditions to exit:
1) The appliance detects that the indoor light is stronger
than the set
ting value for 20 minutes.
2) The appliance is in the 8 h “ SM ART SLEEP” mode.
3 ) The “ LIG HT SENSING ” function is disabled.
When any of the above conditions is met, the appliance will
exit from the “ SM ART SLEEP” mode. Once out of the
“ SM ART SLEEP” mode, the appliance will operate under
the operation status initially set on the
remote controller.
Note: 1) This function is not available in the “ AIR SUPPLY”
mode.
2) This function is not available in the “ SLEEP” mode.
3 ) When it is in the " REM OTE SLEEP” mode or the
“ TIM ER” is on, the app
liance will exit from this function.
4 ) Light sources like indoor lamps and TV ’ s LED
light, and freq uent movement s of pets will affect this
function.
2.
Press “ HEALTH” +“ HEALTH AIRFLOW” simultaneously can
set and cancel the “ LOCK ” function ( )
TIM ER
TIM ER
To Next Page
Loading...
Need help?
General
