Haier AS09DCBHRA - User Manual

Questions and Answers:

S
Sandra HunterAug 4, 2025
Why is my Haier AS09DCBHRA Air Conditioner not cooling properly?
- M
  Mr. Stephen Lester Jr.Aug 5, 2025
  If your Haier Air Conditioner isn't cooling well, several factors could be the cause. First, check the air filter and clean it if it's dirty; it should be cleaned every 15 days. Ensure there are no obstructions blocking the air inlet and outlet. Verify that the temperature is set correctly. Make sure all doors and windows are closed, and use curtains to block direct sunlight. Finally, reduce heat sources or the number of people in the room.
M
mossmatthewAug 11, 2025
What to do if my Haier Air Conditioner is making noise?
- R
  Roger PittmanAug 11, 2025
  During operation, a swishing or gurgling noise may be heard, especially in the first few minutes after starting your Haier Air Conditioner. This is normal and caused by refrigerant flowing in the system. Also, a cracking noise might occur due to the casing expanding or shrinking with temperature changes. Check if the air filter is too dirty.
J
Juan MortonAug 17, 2025
Why does my Haier Air Conditioner not restart immediately?
- J
  Jodi TaylorAug 17, 2025
  Your Haier Air Conditioner is designed with a protective feature that prevents it from restarting immediately after being stopped. This is to protect the system, and it typically takes about 3 minutes before the unit can be restarted. If you unplug and re-plug the unit, this protection circuit will also activate for 3 minutes. Wait for 3 minutes before attempting to restart the unit.
M
Melissa WongAug 23, 2025
Why is my Haier AS09DCBHRA blowing out mist or steam?
- D
  Daniel BautistaAug 23, 2025
  The mist or steam coming from your Haier Air Conditioner is due to the rapid cooling of the indoor air.
E
Elizabeth BarkerAug 29, 2025
Why can’t I change the fan speed in dry mode on my Haier AS09DCBHRA?
- K
  kennethkellyAug 29, 2025
  When your Haier Air Conditioner is in DRY mode, the fan speed cannot be manually adjusted if the room temperature falls below the set temperature plus 2 degrees Celsius. In this condition, the unit will run intermittently at LOW speed regardless of the FAN setting.

Haier AS09DCBHRA Specifications

General

Cooling Capacity	9000 BTU/h
Energy Efficiency Ratio (EER)	3.21
Refrigerant	R410A
Compressor Type	Rotary
Dimensions (Indoor Unit)	805 x 194 x 292 mm
Dimensions (Outdoor Unit)	700 x 245 x 544 mm
Weight (Indoor Unit)	8.5 kg
Power Supply	220-240V, 50Hz
Type	Split Type
Operating Temperature (Cooling)	18°C to 43°C
Noise Level (Indoor)	37 dB(A)

Summary

General Safety Warnings

Installation and Electrical Safety

Critical warnings regarding unit installation, electrical connections, and grounding safety.

Refrigerant and Operational Safety

Safety guidelines for refrigerant handling, storage, and general unit operation.

Parts and Functions

Indoor Unit Components

Identifies and describes the key components of the indoor air conditioner unit.

Remote Controller Overview

Explains the buttons and display functions of the air conditioner remote control.

Setting the Clock

Operating Modes

Quiet;Turbo Operation

How to use the quiet/turbo mode for rest or reading.

Cool, Heat, and Dry Operation

Instructions for selecting cooling, heating, and dry operating modes.

Adjusting Operation Settings

Temperature and Fan Speed Control

Guidance on adjusting the temperature and fan speed settings.

EcoPilot Operation

Explanation of the EcoPilot function for optimized air flow.

Advanced Operation Features

Human Sensing Function (EcoPilot)

Detailed explanation of the human sensing function for automatic air direction.

Health Airflow Operation

How to activate and use the health airflow function for better comfort.

Airflow Direction and Timer

Swing Operation

Controls for adjusting the up/down and left/right airflow direction.

Timer Operation

Instructions for setting automatic operation timers (ON/OFF).

Sleep Mode and Power Recovery

Comfortable Sleep Mode

How to use the sleep mode for comfortable temperature management during rest.

Power Failure Resume Function

Behavior of the unit after a power interruption and how it resumes operation.

Special Operations

Smart Operation

How the smart mode automatically adjusts indoor temperature and humidity.

Self Clean Operation

Instructions for activating the self-cleaning function for the evaporator.

Emergency and Maintenance Operations

Health Operation

Details on the health operation using a water-ion generator for air purification.

Emergency;Test Operation and Battery Loading

Using emergency/test modes and instructions for loading remote batteries.

Refrigerant Information and Demand Response

Refrigerant Details

Information about R32 refrigerant, GWP, and charging.

DRED Operation Modes

Explanation of Demand Response modes for energy management.

Installation Preparation

Necessary Tools and Power Source

Tools needed for installation and power source requirements.

Installation Place Selection

Guidelines for selecting suitable indoor and outdoor unit placement.

Indoor Unit Installation Steps

Mounting Plate and Hole Preparation

How to fit the mounting plate and prepare wall holes for piping.

Connecting Indoor Unit

Steps for connecting the indoor unit body and its electrical wiring.

Piping and Testing

Cable Connection and Drainage

Details on connecting cables and ensuring proper drainage setup.

Cutting, Flaring, and Test Run

Procedures for piping work and final installation test run.

Maintenance and Smart Usage

Tips for Smart Air Conditioner Use

General advice for efficient operation and room temperature setting.

Air Purifying Filter Replacement

Step-by-step guide for replacing the air purifying filter.

Important Cautions

General Operation Prohibitions

Key prohibitions to follow during air conditioner operation.

Installation and Usage Restrictions

Warnings regarding installation environment and usage restrictions.

Troubleshooting Guide

Common Issues and Solutions

Explains common operating problems and their potential causes and solutions.

Specifications and Further Cautions

Technical specifications and additional safety notes for operation.

Customer Support

Contact Information

Contact details for Haier customer support in Australia and New Zealand.

Related product manuals

Haier AS09NS1HRA-Grey

184 pages

Haier AS09NS1HRA-GOLDEN

60 pages

Haier AS09DCBHRA - User Manual

Table of Contents

Questions and Answers:

Haier AS09DCBHRA Specifications

Summary

General Safety Warnings

Installation and Electrical Safety

Refrigerant and Operational Safety

Parts and Functions

Indoor Unit Components

Remote Controller Overview

Setting the Clock

Operating Modes

Quiet;Turbo Operation

Cool, Heat, and Dry Operation

Adjusting Operation Settings

Temperature and Fan Speed Control

EcoPilot Operation

Advanced Operation Features

Human Sensing Function (EcoPilot)

Health Airflow Operation

Airflow Direction and Timer

Swing Operation

Timer Operation

Sleep Mode and Power Recovery

Comfortable Sleep Mode

Power Failure Resume Function

Special Operations

Smart Operation

Self Clean Operation

Emergency and Maintenance Operations

Health Operation

Emergency;Test Operation and Battery Loading

Refrigerant Information and Demand Response

Refrigerant Details

DRED Operation Modes

Installation Preparation

Necessary Tools and Power Source

Installation Place Selection

Indoor Unit Installation Steps

Mounting Plate and Hole Preparation

Connecting Indoor Unit

Piping and Testing

Cable Connection and Drainage

Cutting, Flaring, and Test Run

Maintenance and Smart Usage

Tips for Smart Air Conditioner Use

Air Purifying Filter Replacement

Important Cautions

General Operation Prohibitions

Installation and Usage Restrictions

Troubleshooting Guide

Common Issues and Solutions

Specifications and Further Cautions

Customer Support

Contact Information

Related product manuals