and outlet grills of the air conditioner are opened, and
the unit goes on working under the condition before the
grille will close automatically.
Notice:
Cannot pull direct the outlet grille by hand. Otherwise, the
grille will run incorrectly. If the grille is not run correctly,
stop for a minute and then start, adjusting by remote
controller.
Remote controller can memorize each operation status.
when starting it next time, just press ON/OFF button and
unit will run in previous status.
The setting of
function
The cancel of
function
Operation
HEALTH AIRF LOW OperationECOP ILOT Operation
appears on the display. Avoid
the body.
again,
appears on the display.
direct to the body.
Note:
2. In heating, it is better to select the mode.
3 . In cooling, it is better to select the
mode.
4 . In cooling and dry, using the air conditioner for a
long time under the high air humidity, a phenomenon
falling drips of water occurs at the outlet grille.
5. Select the appropriate fan direction according to the
actual conditions.
TIM ER
7
Human Sensing Function
1. “ Follow” function: It can detect where a person is and
adjust the swing flap accordingly and send air to the
location of this person. If it detects people in two
locations, the swing flap will blow alternatively between
these two locations and stay at each location for 15s. If
the appliance detects people in three or more locations,
the left and right swing flaps will swing automatically.
“ Avoid” function: When the appliance detects a person in
a location, it will adjust the swing flap to avoid such a
location. If it detects people in three or more locations,
the left and right swing flaps will swing automatically.
Note:
1) When there are people in several locations or a
person freq uently moves between several locations,if this
person is in the in- between location or the crossing
location, whether the appliance is in a “ Follow” mode or
an“ Avoid” mode, thes wing flap will swing automatically to
send air to these locations.
2) Whether the setting is “ Follow” or “ Avoid” , it takes some
time to adjust theair direction after the appliance identifies
the location of the people and the air direction will not
change immediately.
3 ) If the actual airflow cannot reach ( or avoid) the location
where a person is due to such factors as fan speed setting,
temperature setting, ambient temperature difference and
layout of the room, pressing the left and right swing flaps
can adjustthe air direction and set the airflow direction by
hand.
4 ) Set the health airflow when the human sensing
( including follow/avoid) function is enabled and exit from
the human sensing ( including follow/avoid) function.
5) Press the upper and lower swing flaps when the human
sensing ( including follow/avoid) function is enabled, there
is no upper and lower full swing status.
6 ) When the appliance is in the upper and lower full swing
status, set the human sensing function ( including
follow/avoid) , the upper and lower swing flaps are in their
standard positions of relevant mode.
2. When the human sensing function is enabled, if the
appliance cannot detects people for a long time ( at least
20 minutes) , it will automatically enter the power saving
mode. In the power saving mode, the operating freq uency
will lower down and the fan speed is low. Once a person is
detected, the appliance will exit from the power saving mode.
To Next Page
Loading...
