EN
5 - Use
11
5.1 Before rst Use
▶ Remove all packaging materials, keep them out of childrens reach and dispose them
in an environmentally friendly manner.
▶ Clean the inside and outside of the appliance with water and a mild detergent before
putting any food in it.
▶ After the appliance has been levelled and cleaned, wait for at least 6 hours before con-
necting it to the power supply. See Section INSTALLATION.
▶ Precool the compartment for 2 hours at high settings before loading with food. To do
so, please set the temperature to -20 °C or -24 °C.
5.2 Switching the appliance on /o
The appliance is in operation as soon as it is connected to the power supply.
▶ The freezer temperature is automatically set to -18 °C. This is the recommended set-
ting and the ideal temperature for frozen goods. If desired, you can change the tem-
peratures manually. Please see ADJUSTING THE TEMPERATURE.
Indicators (a-g) will ash once consequtively. If the door is closed, the display switches o
after 30 seconds. The panel lock might be active.
Notice: Presettings
▶ The appliance is preset to the recommended temperature of -18 °C. Under normal
ambient condition you don´t need to set a temperature.
▶ When the appliance is switched on after being disconnected from the main power
supply, it may take up to 12 hours for the correct temperature to be reached.
Empty the appliance before switching o. To switch o the appliance, pull the power cord
out o the power socket.
5.3 Standby-mode of display
When the door is closed the display screen turns o automatically 30 seconds after without
operation. The display locks automatically. It lights up automatically when touching any but-
ton or opening the door.
5.4 Display lock and unlock
Automatic locking
Display is automatically locked after 30 seconds without operation.
Manual locking
When the display is unlocked, press “Child lock” (G) and hold for 3 seconds, after a beep,
“Child lock”(g) indicator is light, display is locked. When the display is locked, press “Child
lock” (G) and hold for 3 seconds, after a beep, “Child lock”(g) indicator is o, display is un-
locked.
To Next Page
Loading...
Need help?
General
