10 - Installation
EN
20
10.1 Unpacking
▶
WARNING!
▶ The appliance is heavy. Always handle with at least two persons.
▶ Keep all packaging materials out of childrens reach and dispose them in an environ-
mentally friendly manner.
Take the appliance out of the packaging.
▶ Remove all packaging materials.
10.2 Environmental conditions
The room temperature should always be between 10 °C and 43 °C, since it can inuence
the temperature inside the appliance and its energy consumption. Do not install the appli-
ance near other heat-emitting appliances (ovens, refrigerators) without isolation.
10.3 Space requirements
Required space to open the door (Fig. 10.3):
Width
in mm
Depth
in mm
Distance to wall
in mm
W1 W2 D1 D2 D3 D4
595 955 592 1105 1215 100
10.4 Ventilaton cross-section
To achieve sucient ventilation of the appliance for
safety reasons, the information of the required ventila-
tion cross sections must be observed (Fig. 10.4).
10.5 Aligning the appliance
The appliance should be placed on a at and solid sur-
face. If the appliance is placed on a pedestal, strong and
re-resistant materials must be used. Never use the
foam packing material as a pedestal.
1. Tilt the appliance slightly backwards (Fig. 10.5).
2. Set the feet to the desired level.
3. The stability can be checked by alternately bump-
ing on the diagonals. The slight swaying should be
the same in both directions. Otherwise the frame
can warp; possible leaking door seals are the result.
A low tendency to the rear eases the closing of the
door.
W2
D1
D3
D2
W1
D4
10.3
10 cm
10 cm
10 cm
10 cm
10.4
1.
2.
3.
10.5
To Next Page
Loading...
Need help?
General
