24
REINSTALLING/USING WASHER AGAIN
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove the ground prong from the power cord plug.
Do not use an adapter.
Do not use an extension cord.
Failure to do so can result in death, fire or electrical shock.
To reinstall washer after non-use, vacation, winter storage or moving:
1. Refer to Installation Instructions to locate, level, and connect washer.
2. Before using again, run washer through the following recommended procedure:
To use washer again:
1. Flush water pipes and hoses. Reconnect water inlet hoses. Turn on both water
faucets.
2. Plug in washer or reconnect power.
3. Run washer through Wash cycle to clean washer and remove antifreeze, if used.
NOTE: Use only HE High Eciency detergent. Use half the manufacturer’s
recommended amount for a medium-size load.
To Next Page
Loading...
Need help?
General